VTech Go! Go! Smart Wheels Ultimate Corkscrew Tower - Battery Installation; Battery Usage Guidelines

7
7
7
7
GETTING STARTED
Battery Removal and Installation
Race Car
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the Race Car and use a
screwdriver to loosen the screw and
open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box.
5. Replace the battery cover and tighten
the screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable, or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Removerechargeablebatteriesfrom thetoybeforecharging (if
removable).
• Rechargeablebatteries areonly to be chargedunder adult
supervision.