13
10. If the elevator track piece is at the base of the SmartPoint
®
elevator,
lift the elevator track piece up. Then, attach the elevator ramp
track to the SmartPoint
®
elevator as shown below. You will hear
a “click” sound to indicate the elevator ramp track is secure. Once
the elevator ramp track is attached to the SmartPoint
®
elevator, it
cannot be detached.
11. Insert the two switch track pieces into the two switch track bases
as shown below. You will hear a “click” sound to indicate the switch
track pieces are secure. Once the switch track pieces are attached
to the switch track bases, they cannot be detached.
Assembly Instructions
To Next Page
Loading...
