VTech Grip & Go Steering Wheel - Getting Started; Battery Removal and Installation; Battery Notice

4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the back of the
steering wheel. Use a screwdriver to loosen
the screw and then open the battery cover.
3. Remove old batteries by pulling up on one
side of each battery.
4. Install 2 new AAA batteries following the
diagram inside the battery box.
5. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable, or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Removerechargeablebatteriesfromthetoybeforecharging
(ifremovable).
• Rechargeablebatteries are only to becharged under adult
supervision.