VTech I See Me Lion Mirror - Getting Started: Battery Installation and Information; Battery Removal and Installation Guide; Important Battery Information

4
4
4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
back of the unit. Use a screwdriver to
loosen the screw and then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA batteries following
the diagram inside the battery box.
(For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Do not mix alkaline, standard (carbon-zinc)orrechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommendedare
to be used.
• Donotshort-circuitthesupplyterminals.
• Removebatteriesduringlongperiodsofnon-use.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.