VTech Marble Rush Shuttle Blast-Off Set - Instructions; Battery Removal and Installation

4
WARNING
Do not discharge any object other than the projectile provided with
this toy.
ATTENTION
Ne viser ni les yeux ni le visage.
ATTENTION
Ne pas utiliser d’autres projectiles que ceux fournis avec ce jouet.
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located
on the back of the unit, use a
screwdriver to loosen the screw
and then open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install2newAA(LR6/AM-3)batteriesfollowingthediagraminside
thebatterybox.(Forbestperformance,alkalinebatteriesorfully
chargedNi-MHrechargeablebatteriesarerecommended.)
5. Replacethebatterycoverandtightenthescrewtosecure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Lespilesouaccumulateursdoiventêtreinstallésparunadulte.
Tenir les piles ou accumulateurs hors de portée des enfants.