EasyManua.ls Logo

VTech MARVEL SPIDEY and his AMAZING FRIENDS Marble Rush Go-Spidey-Go! Set - Battery Setup and Information; Battery Removal and Installation

VTech MARVEL SPIDEY and his AMAZING FRIENDS Marble Rush Go-Spidey-Go! Set
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
WARNING:
CHOKING HAZARD -Toy contains
small parts and small balls.
Not for children under 3yrs.
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located
on the back of the unit, use a
screwdriver to loosen the screw
and then open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 3 new AAA (LR03/AM-4) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.

Related product manuals