4
G E T T I N G S TA R T E D
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Find the battery cover located on the
bottom of the Plastic Book, use a
screwdriver to loosen the screw and then
open the battery cover.
3. Remove the old batteries by pulling the
end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH
rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING
Adult assembly required for battery installation.
Keep batteries out of reach of children.
To Next Page
Loading...