VTech Pop-a-balls Pop & Count Ball Pit - GETTING STARTED; Battery Installation and General Information

5
5
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the back
of the electronic tree activity panel.
Use a screwdriver to loosen the
screw and open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 3 new AAA batteries following
the diagram inside the battery box.
Replace the battery cover and tighten
the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in re.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.