EasyManuals Logo

VTech Press & Pull Racer User Manual

VTech Press & Pull Racer
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the
bottom of the race car. Use a coin or
screwdriver to loosen the screw and
open the battery cover.
3. Remove old batteries by pulling up on
one side of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (The use of new alkaline batteries is
recommended for maximum performance.)
5. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance
• Useonlybatteriesofthesameorequivalenttypeasrecommended
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable, or new and used batteries
• Donotusedamagedbatteries
• Insertbatterieswiththecorrectpolarity
• Donotshort-circuitthebatteryterminals
• Removeexhaustedbatteriesfromthetoy
• Removebatteriesduringlongperiodsofnon-use
• Donotdisposeofbatteriesinfire
• Donotchargenon-rechargeablebatteries
Removerechargeablebatteriesfromthetoybeforecharging
(if removable)
Rechargeable batteries are onlyto be charged under adult
supervision
528400 IM .indd 4 09/06/2019 9:10:14

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VTech Press & Pull Racer and is the answer not in the manual?

VTech Press & Pull Racer Specifications

General IconGeneral
BrandVTech
ModelPress & Pull Racer
CategoryToy
LanguageEnglish

Related product manuals