VTech Pups to the Rescue Driver User Manual

3
INCLUDED IN THIS PACKAGE / GETTING STARTED
INCLUDED IN THIS PACKAGE
• OneVTech
®
Pups to the Rescue Driver™
• User’smanual
WARNING:
All packing materials, such as tape, plastic sheets, packaging
locks and tags are not part of this toy, and should be discarded
for your child’s safety.
NOTE:
Please keep this user’s manual as it contains important information.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the unit.
3. Use a screwdriver to open the cover.
4. Install 2 new “AA” size (LR6/AM-3)
batteries following the diagram inside
the battery box. (The use of new,
alkaline batteries is recommended for
maximum performance.)
5. Replace the battery cover and tighten
the screw to secure.
Note: If there is no response when the unit is switched on, please
insert new batteries and try switching it on again.
Unlock the packaging locks:
Rotate the packaging locks 90 degrees
anti-clockwise.
Pull out the packaging locks.

VTech Pups to the Rescue Driver Specifications

General

Brand	VTech
Model	Pups to the Rescue Driver
Category	Toy
Language	English