VTech Rattle & Sing Puppy - GETTING STARTED; BATTERY INSTALLATION; BATTERY NOTICE

5
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the
unit. Use a screwdriver to loosen the screw.
3. Install 3 new button cell batteries (LR44)
following the diagram inside the battery
box. (The use of a new alkaline battery is
recommended for maximum performance.)
4. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• UsethreeLR44Alkalinebuttoncellbatteriesonlyforthistoy.
• Thebuttoncellbatteriesusedwiththisproductshouldbekeptaway
from small children who might still put things in their mouths. If the
button cell batteries are swallowed, consult a doctor immediately.
• Insertthebuttoncellbatterieswiththecorrectpolarity.
• Donotusedamagedbuttoncellbatteries.
• Donotshort-circuitthebuttoncellbatteryterminals.
• Removeexhaustedbuttoncellbatteriesfromtheproduct.
• Removebuttoncellbatteriesduringlongperiodsofnon-use.
• Donotdisposeofbuttoncellbatteriesinfire.
• Donotchargenon-rechargeablebuttoncellbatteries.
• Removerechargeablebatteriesfromthetoybeforecharging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Donotmixoldandnewbatteries.
• Do not mix batteries of different types: alkaline, standard
(carbonzinc) or rechargeable (nickel-cadmium).
DO NOT USE RECHARGEABLE BATTERIES.
Getting Started