Positioning the baby monitor
Place the parent unit within the operating
range of the baby unit. We recommend the
parent unit is at least 1 meter (3 feet) away
from the baby unit to avoid audio feedback. If
you still experience audio feedback, move the
parent unit and the baby unit farther apart.
Operating range
The operating range of the baby monitor is
up to 300 meters (1000 feet) outdoors or
50 meters (160 feet) indoors. The actual
operating range may vary depending on
the environmental conditions, and other
interferences such as walls, doors, and other
obstructions.
Baby unit overview
Parent unit overview
User’s manual
DM111/DM111-2
Safe & Sound
TM
audio monitor
Congratulations
on purchasing your new VTech product.
Before using this product, please read
Important safety instructions in this manual.
For support, shopping, and everything new
at VTech, visit our website at
www.vtechphones.com. In Canada, please
visit www.vtechcanada.com.
Register online to get an additional
3-month warranty!
Visit www.vtechphones.com.
Registration
Register your product online for
enhanced warranty support.
Product news
Learn about the latest VTech
products.
When using your equipment, basic safety precautions
should always be followed to reduce the risk of re,
electric shock and injury, including the following:
1. Follow all warnings and instructions marked on
the product.
2. Adult setup is required.
3. This product is intended as an aid. It is not
a substitute for responsible and proper adult
supervision and should not be used as such.
4. This product is not intended for use as a
medical monitor.
5. Do not use this product near water. For example,
do not use it next to a bath tub, wash bowl,
kitchen sink, laundry tub or swimming pool, or in
a wet basement or shower.
6. CAUTION: Use only alkaline batteries (not
included). There may be a risk of explosion if a
wrong type of battery is used for the parent unit.
Do not dispose of batteries in a re. They may
explode. Check with local codes for possible
special disposal instructions.
7. Do not open or mutilate the batteries. Released
electrolyte is corrosive and may cause burns or
injury to the eyes or skin. The electrolyte may be
toxic if swallowed.
8. Exercise care in handling the batteries in order not
to create a short circuit with conductive materials.
9. Observe proper polarity orientation between the
batteries and metallic contacts.
10. Use only the adapters included with this product.
Incorrect adapter polarity or voltage can seriously
damage the product.
Baby unit power adapter: Input 117V AC 60 Hz;
output: 6V AC 300 mA
Parent unit power adapter: Input 100-120V AC
60 Hz; output: 6V DC 400 mA
11. The power adapters are intended to be correctly
oriented in a vertical or oor mount position. The
prongs are not designed to hold the plug in place
if it is plugged into a ceiling, under-the-table or
cabinet outlet.
12. Unplug this product from the wall outlet before
cleaning. Do not use liquid or aerosol cleaners.
Use a damp cloth for cleaning.
13.
Unplug the power cords before replacing the batteres.
14. Do not cut off the adapters to replace them with
other plugs, as this causes a hazardous situation.
15. Do not allow anything to rest on the power cords.
Do not install this product where the cords may
be walked on or crimped.
16. This product should be operated only from the type
of power source indicated on the marking label. If
you are not sure of the type of power supply in your
home, consult your dealer or local power company.
17. Do not overload wall outlets or use an extension cord.
18. Do not place this product on an unstable table,
shelf, stand or other unstable surfaces.
19. This product should not be placed in any area
where proper ventilation is not provided. �lots�lots
and openings in the back or bottom of this
product are provided for ventilation. To protect
them from overheating, these openings must
not be blocked by placing the product on a soft
surface such as a bed, sofa or rug. This product
should never be placed near or over a radiator or
heat register.
20. Never push objects of any kind into this product
through the slots because they may touch
dangerous voltage points or create a short circuit.
Never spill liquid of any kind on the product.
21. To prevent re or shock hazard, do not expose
this product to water or any type of moisture.
22. To reduce the risk of electric shock, do not
disassemble this product, but take it to an authorized
service facility. Opening or removing parts of the
product other than specied access doors may
expose you to dangerous voltages or other risks.
Incorrect reassembling can cause electric shock
when the product is subsequently used.
23. You should test the sound reception every time you
turn on the units or move one of the components.
24. Periodically examine all components for damage.
25. Be aware of possible loss of privacy while using
public airwaves. Conversations may be picked
up by other nursery monitors, cordless phones,
scanners, etc.
26. Children should be supervised to ensure that
they do not play with the product.
27. The product is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
SAVE THESE INSTRUCTIONS
Cautions
Use and store the product at a temperature
between 32
o
F and 104
o
F.
Do not expose the product to extreme cold, heat
or direct sunlight. Do not put the product close to
a heating source.
The batteries should not be exposed to excessive
heat such as bright sunshine or re.
Make sure the baby unit and the adapter cord are
always out of reach of the baby, at least 1 meter
(3 feet) away from the baby or crib, to avoid a
possible strangulation hazard.
Other electronic products may cause
interference with your audio monitor. Try
installing your audio monitor as far away
from these electronic devices as possible:
wireless routers, radios, cellular telephones,
intercoms, room monitors, televisions,
personal computers, kitchen appliances and
cordless telephones.
1.
2.
3.
4.
5.
Never place the baby unit inside the baby’s crib
or playpen.
Never cover the baby unit or parent unit(s) with
anything such as a towel or a blanket.
Precautions for users of implanted cardiac
pacemakers
Cardiac pacemakers (applies only to digital
cordless devices):
Wireless Technology Research, LLC (WTR), an
independent research entity, led a multidisciplinary
evaluation of the interference between portable
wireless devices and implanted cardiac pacemakers.
�upported by the U.�. Food and Drug Administra-
tion, WTR recommends to physicians that:
Pacemaker patients
�hould keep wireless devices at least six inches
from the pacemaker.
�hould NOT place wireless devices directly over
the pacemaker, such as in a breast pocket, when
it is turned ON.
WTR’s evaluation did not identify any risk to
bystanders with pacemakers from other persons
using wireless devices.
Electromagnetic elds (EMF)
This VTech product complies with all standards
regarding electromagnetic elds (EMF). If handled
properly and according to the instructions in this
user’s manual, the product is safe to be used based
on scientic evidence available today.
6.
7.
•
•
Connect
Connect the parent unit
Before use
You may test the baby monitor before initial
use, and at regular times thereafter.
To test your baby monitor:
Place the parent unit and the baby unit in the
same room to test the product.
Press and hold on the baby unit until the
POWER light turns off.
Press and hold on the baby unit again
until the POWER light turns on.
Press and hold on the parent unit the
POWER/LINK light turns off.
Press and hold on the parent unit again
until the POWER/LINK light turns on.
1.
2.
3.
4.
5.
If the parent unit is not linked to the baby unit,
the POWER/LINK light on the parent unit will
ash. Move the parent unit closer to the baby
unit (but not less than 1 meter / 3 feet).
•
1
–
POWER light
2
–
(On/off)
Press and hold to turn on or off the
baby unit.
3
–
Microphone
4
–
Power jack
Overview
POWER / LINK
POWER/LINK light
Lights off when the parent unit
is off.
Lights on in green when the
parent unit is on and linked to
the baby unit.
Flashes in green when there is
no link between the baby unit
and parent unit, or when the
parent unit is out of range from
the baby unit.
•
•
•
Visual sound indicator
The visual sound indicator shows
the sound level detected from
the baby unit. It also shows the
volume level during speaker
volume setting.
�ound level detected from the baby
unit is indepedent from the volume
level set at the parent unit.
Green lights indicate a
moderate sound level detected
from the baby unit; or
Level 1 to Level 3 of the
speaker volume setting.
Red lights indicate a higher
sound level detected from the
baby unit; or
Level 4 to Level 5 of the
speaker volume setting.
•
•
•
•
LOW BATTERY
LOW BATTERY light
Flashes in red when the
battery is low.
•
POWER
POWER light
Lights off when the baby unit
is off.
Lights on in green when the
baby unit is on.
•
•
1
–
Visual sound indicator
2
–
POWER/LINK light
3
–
LOW BATTERY light
4
–
(Volume down)
Press to decrease
the speaker volume.
5
–
(On/off)
Press and hold to turn on or off the
parent unit.
6
–
Speaker
Listen to sounds transmitted from the
baby unit.
7
–
(Volume up)
Press to increase
the speaker volume.
8
–
Belt clip
9
–
Battery compartment cover
10
–
Power jack
Baby unit light
Parent unit light
Using your baby monitor
Power on or off the baby unit
To turn on the baby unit:
Press and hold until the POWER light
turns on.
To turn off the baby unit:
Press and hold until the POWER light
turns off.
Power on or off the parent unit
To turn on the parent unit:
Press and hold until the POWER/LINK
light turns on.
To turn off the parent unit:
Press and hold unit the POWER/LINK
light turns off.
•
•
•
•
To Next Page
Need help?
General
