6
ASSEMBLY INSTRUCTIONS
1. Screw the handle to the top of the activity
panel with six of the small screws. Check
the handle to make sure it is attached
securely.
2. Screw the two back wheels to the
underside of the walker legs with eight
of the small screws. Check the wheels to
make sure they are attached securely.
3. Insert the two front wheels into the slots
on the bottom of the activity panel. You
will hear the wheels click into place when
inserted correctly. To remove the front
wheels, press the release locks toward
the centre and pull out the wheels.
Assembly Instructions
With the VTech
®
Sit, Stand & Ride Baby Walker™ safety comes
rst. To ensure your child’s safety, adult assembly is required. After
assembling in the walker or the ride-on position, please make sure
the unit is assembled correctly before giving it to your child. Please
keep the walker legs and wheels out of toddlers reach when not
using the unit as a walker or ride-on.
To Next Page
Loading...