VTech Spinning Spiral Tower Playset - ASSEMBLY INSTRUCTIONS

6
ASSEMBLY INSTRUCTIONS
With the VTech
®
Go! Go! Smart Wheels
®
Spinning Spiral Tower
Playset
TM
, safety comes first. To ensure your child’s safety, adult
assemblyisrequired.
Assemble the spiral tower:
1. Locate the tower base that is labeled
with a number “1” engraving on the
bottom. Insert three tower support
pieces as shown.
2. Place the spiral ramp piece with the
number “2” engraving on the bottom
over the center pole on the tower base.
Then adjust the spiral ramp piece so
the slots on the bottom fit snugly onto
the two support pieces as shown.
3. Attach the spiral ramp piece with the
number “3” engraving on the bottom
in the same way. Adjust it so the spiral
fits snugly over the remaining support
piece.
4. Insert the final two support pieces
into the slots of the spiral ramp with
the number “2” engraving.
Assembly Instructions