BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of
one of the poles. Use a screwdriver to
loosen the screw.
3. Install 2 new “AA” (UM-3/LR6) batteries
following the diagram inside the battery
box. (The use of new alkaline batteries
is recommended for maximum
performance.)
4. Replace the battery cover and tighten
the screw to secure the battery cover.
BATTERY NOTICE
• Install batteries correctly observing the polarity ( +, - ) signs to
avoid leakage.
• Do not mix old and new batteries.
• Do not use batteries of different types.
• Remove exhausted or new batteries from the equipment when the
unit will not be used for an extended period of time.
• Do not dispose of batteries in fire.
• Do not attempt to recharge ordinary batteries.
• The supply terminals are not to be short-circuited.
• Only batteries of the same and equivalent type as recommended
are to be used.
WE DO NOT RECOMMEND THE USE OF RECHARGEABLE
BATTERIES.
Instructions & Activities
4
To Next Page
Loading...
Need help?
General