VTech Switch & Go Spinosaurus Race Car User Manual

3
INCLUDED IN THIS PACKAGE
• Switch & Go™ Spinosaurus Race Car
• Parent’s guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties and packaging screws are not part of this
toy, and should be discarded for your child’s safety.
NOTE
Please keep this parent’s guide as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les
produits d’emballage tels que rubans adhésifs, feuilles de plastique,
attaches, étiquettes et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de conserver ce guide des parents car il comporte des
informations importantes.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on
the bottom of the unit and use a
screwdriver to loosen the screw
and open the battery cover.
3. Remove the old battery by pulling
up on one end of it.
4. Install 1 new AAA (LR03/AM-4)
battery following the diagram
inside the battery box.
5. Replace the battery cover and
tighten the screw to secure.

VTech Switch & Go Spinosaurus Race Car Specifications

General

Brand	VTech
Model	Switch & Go Spinosaurus Race Car
Category	Toy
Language	English