3
INCLUDED IN THE PACKAGE
• Switch & Go
®
Velociraptor Motorcycle
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE
Please keep this instruction manual as it contains important information.
ATTENTION :
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes et vis d’emballage. Ils ne font pas partie du jouet.
NOTE :
Il est conseillé sauvegarder ce manuel d’utilisation car il comporte des
informations importantes.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
roof of the unit. Use a screwdriver to
loosen the screw, and then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 1 new AAA (LR03/AM-
4) battery following the diagram
inside the battery box. (For best
performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
To Next Page
Loading...
Need help?
General