5
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
Riot the T-Rex
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the unit.
Loosen the screw and remove the cover.
3. If used or spent batteries are present, remove
them by pulling up on one end of each battery.
4. Install 4 new AA (LR6/AM-3) batteries following
the diagram inside the battery box. (The use
of new alkaline batteries is recommended for
maximum performance).
5. Replace the battery cover.
Remote Control
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of
the unit. Loosen the screw and remove the cover.
3. If used or spent batteries are present,
remove them by pulling up on one end of
each battery.
4. Install 2 new AAA batteries following the
diagram inside the battery box. (The use of
new alkaline batteries is recommended for maximum performance).
5. Replace the battery cover.
BATTERY NOTICE
• Alkaline Batteries are recommended. Rechargeable batteries are
not guaranteed to provide the best performance for this product.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
To Next Page
Loading...
Need help?
General