VTech SWITCH&GO HATCH & ROAAAR EGG T-REX RACER - Getting Started with Your Toy; Exiting Try-Me Mode; Battery Installation and Safety

4
GETTING STARTED
Exit Try-Me Mode:
The product is in Try Me mode in the packaging. To exit try-me
mode, just slide the “Off/Dino Mode/Vehicle Mode” Switch from
Vehicle mode to Dino mode/Off.
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit, use a screwdriver to
loosen the screw, and then open the
battery cover.
3. Remove the old battery by pulling up on
one end of the battery.
4. Install 1 new AAA (AM-4/LR03) battery
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten
the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.