5
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the unit. Use a screwdriver
to loosen the screw.
3. If used batteries are present, remove
these batteries from the unit by
pulling up on one end of each battery.
4. Install 4 new AA (AM-3/LR6)
batteries following the diagram inside the battery box.
(For best performance, alkaline batteries or fully charged Ni-MH
rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
Remote Control
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back
of the unit. Use a screwdriver to
loosen the screw.
3. If used batteries are present, remove
these batteries from the unit by
pulling up on one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside the battery box.
(For best performance, alkaline batteries or fully charged Ni-MH
rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
To Next Page
Loading...
Need help?
General