Mount the baby monitor
Use a pencil to mark two holes in
parallel. Make sure they are the
same distance apart as the wall
mount at the bottom of the baby
unit.
Drill two holes in the wall (7/32” drill
bit). If you drill the holes into a stud,
insert the screws into the holes.
Tighten the screws until only 1/4 inch
of the screws are exposed.
Align the holes on the wall mount
with the screws on the wall.
Slide the wall mount down until it
locks into place.
Pan or tilt to adjust the baby unit
angle.
Check for reception strength and
camera angle before drilling the
holes.
To Previous Page
Loading...
