Quick Reference Guide
VTech VSP601
4
WALL MOUNTING THE CHARGER
The charger is ready for tabletop use. If you want to
mount the charger on a wall, use two 10 mm (3/8 inch)
screws and wall anchors to hold the charger in place.
Screws and wall anchors are not provided, but are
available for purchase at hardware retailers. You might
need a professional to install the charger.
To mount the charger on the wall:
1.
Use a pencil to mark the desired positions of
the two holes on the wall. Make sure the space
between the two holes is 30 mm (1 3/16 inches).
Drill two holes in the wall according to the marks.
Screw spacing 30 mm
(1 3/16 inches)
2.
If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a
stud, insert the wall anchors into the holes and tap
gently on the ends with a hammer until the wall
anchors are ush with the wall.
3.
Insert the screws into the holes and tighten them
until only 6 mm (1/4 inch) of the screws are
exposed.
4.
Align the holes at the back of the charger with the
screws on the wall and slide the charger down
until it locks into place.
ADDING A CORDED HEADSET
You can use this handset hands-free when you install
any industry-standard 2.5 mm corded telephone headset
(purchased separately).
Plug a 2.5 mm headset
into the HEADSET jack on
the side of the handset.
To Next Page
Loading...
Need help?
General
