The 12 mm rear axle is secured with a
socket bolt at both ends. Use a hex key to
loosen the non-drive side bolt, then remove
axle from drive side. See your bicycle
owner’s manual for installation and setup
instructions.
3. TRACK WHEELS
Hex nuts which are threaded onto the hub
axle and tightened or loosened with a wrench.
WARNING: Never ride your bike if
wheels, axles or QRs are loose or levers
are in open position. Never use a skewer
with missing springs, bent or broken skewer
shaft, or broken or non-working lever.
VUELTA & ZEROLITE WHEELSET OWNER’S MANUAL
3.
To Next Page
Loading...