Connection Way
Bluetooth connection
Actions
Pairing
Connected
Disconnected
manually
Reconnect
Clear Bluetooth
pairing list
Notes
Operation
Active the pairing function on your
phone or other compatible Bluetooth
device and select "W-KING Tl 1
Active the pairing function on your
phone or other compatible Bluetooth
device and select "W-KING Tl 1 "
Long press the play / pause
button for 2 seconds.
The speaker will reconnect with the
last device when powered on.
Press and hold the play / pause
button for 10 seconds.
LED status
Blue LED stays on
(successfully paired)
Blue LED stays on
(successfully paired)
Blue LED flashes
Blue LED stays on
(successfully paired)
Cyan-blue LED
flashes for 3 times
To reset the speaker (to clear the pairing list or any program errors),
use a straightened paper clip or a toothpick to carefully short-press the
reset hole .
The speaker will automatically shut down after 10 minutes in pairing
mode if no devices are paired
If your paired device is switched off or manually disconnected, the
speaker will enter pairing mode and automatically shut down after 10
minutes
e If the speaker or connected device exceeds the operating range, the
speaker will disconnect. The connection to the last successfully
connected device will be re-established once you re-enter wireless
range within 10 minutes. To connect to other devices, please repeat the
previous "Pairing" steps
05
To Next Page
