Other Connection ways
Actions
USB Drive
Playback
TF Card
Playback
Aux Mode
Notes
Operation
Plug your USB drive to the
USB port of the speaker,
Power on the speaker and
press the play /pause button.
Just Insert TF card to
enter T-flash card mode.
Just Insert 3.5mm Audio
Cable to enter AUX mode.
LED status
Play: Steady green light
(indoor mode)
Play: Green flashes
slowly (outdoor mode)
Pause: Green light flashes
Play: Steady green light
(indoor mode)
Play: Green light flashes slowly
(outdoor mode)
Pause: Green light flashes
Play: Steady green light
(indoor mode)
Play: Green light flashes slowly
(outdoor mode)
Pause: Green light flashes
O The speaker will disconnect from your phone or other paired device
when an audio cable is plugged into the audio input jack.
When playing audio using the audio input jack, press the volume + / - to
adjust the volume. and short-press play/pause to pause or resume. Next /
previous track control on the speaker is disabled in audio input mode.
O For some computers, you may need to access the audio control panel
to manually set the speaker as the default audio device.
06
To Next Page
