WAC Lighting EN-1260-RB2

To Next Page

Retain these instructions for future service and adjustments

44 Harbor Park Drive, Port Washington, NY 11050

Tel: (800) 526-2588 Fax (800) 526-2585

www.waclighting.com

INSTRUCTIONS Class II Electronic Transformer

Model EN-1260-RB2

CAUTION – TO REDUCE RISK OF FIRE AND ELECTRICAL SHOCK

 Always turn off power at main switch prior to installation.

 Intended for installation by a qualified electrician.

 System is intended for installation in accordance with National Electric Code, and local

regulations. Consult with local inspector to assure compliance.

MAX LOAD 60W

MIN LOAD 20W

INPUT VOLTAGE 120V

INPUT CURRENT 0.53A

OUTPUT VOLTAGE 11.6V

CASE TEMP

90ºC (194F)

AMBIENT TEMP

-20ºC TO 50ºC (-4F TO 122F)

FEATURES:

 Electronic short circuit protection with auto-reset.

 Overload protection with auto-reset.

 Automatic thermal regulation.

 Soft start delay to preserve bulb life, for use with tungsten filament lamps.

INSTALLATION

1. Use a minimum of #18 AWG for the output wire.

2. Transformers must be installed away from heat sources and accessible for service.

3. Note: Enclosed transformer is UL listed. The transformer box has a separate line volt,

and low volt wiring compartments. Trade size knock out are provided on both

compartments. Connect building wires to like color transformer wires with wire nuts.

Building ground wire may be green or un-insulated, and attaches to green wire from

transformer box.

4. Connect out put wires from transformer to fixture wires with wire nuts. Where multiple

fixtures are involved several fixtures wires can be joined by use of the same wire nut.

Wires to fixture

Need help?

Do you have a question about the WAC Lighting EN-1260-RB2 and is the answer not in the manual?

Summary

Safety Precautions and Electrical Warnings

General Safety Instructions

Always turn off power before installation and ensure installation by a qualified electrician, adhering to codes.

Product Features

Electronic Protection Systems

Features auto-reset for short circuit and overload protection, plus automatic thermal regulation.

Soft Start Delay

Includes a soft start delay mechanism designed to preserve bulb life, specifically for tungsten filament lamps.

Installation Guide

Wiring and Transformer Placement

Use #18 AWG output wire, install away from heat, connect to like-colored wires, and ensure proper grounding.

Fixture Wire Connection

Connect output wires to fixture wires using wire nuts, joining multiple fixture wires if needed.

Voltage Drop Guidelines

Maximum Wire Lengths by Wattage and Gauge

Provides guidelines for maximum wire lengths based on wattage (20W, 40W, 60W) and wire gauge (18, 16, 14, 12 AWG).