Need help?Do you have a question about the Wacker Neuson BTS 1035-7975 and is the answer not in the manual?
General| Brand | Wacker Neuson |
|---|---|
| Model | BTS 1035-7975 |
| Category | Cordless Saw |
| Language | English |
Technical specifications for BTS 930, 935, 1030, and 1035 models.
Procedure for removing the clutch and drum assembly.
Steps for attaching the muffler and heat plate.
Information on diagnosing and fixing clutch issues.
Instructions for reassembling the clutch and drum.
Method for inspecting and testing the spark plug.
Guide for replacing the spark plug connector.
Steps for removing and reinstalling ignition and short circuit cables.
Procedures for handling the ignition armature.
Instructions for removing and installing the flywheel.
Steps for removing and installing the starter and return spring.
How to pretension and check the return spring.
Procedure for replacing the starter ratchet component.
Instructions for adjusting the carburetor's settings.
Steps for detaching the carburetor and intake hose.
How to disassemble and test the carburetor's control side.
How to disassemble and test the carburetor's pump side.
Procedure for cleaning the fuel filter.
Maintenance and cleaning of the air filter system.
Adjustments for operating the saw in cold weather.
Steps for detaching and reattaching the front handle.
Procedure for replacing vibration dampening components.
How to replace the fuel tank's ventilation valve.
Guide for replacing the throttle control components.
Steps for changing the fuel line.
Method for checking and replacing the fuel filter.
Procedures for removing and installing the cylinder and piston.
How to test the decompression valve's function.
Procedures for handling the crankcase and crankshaft components.
Steps for replacing the pressure disc.
Guide for V-belt pulley removal and installation.
Procedure for replacing the drive axle.
Steps to remove the entire pressure ring assembly.
Details on mounting cutter guard holding components.
How to replace the guard stop mechanism.
Procedure for replacing a specific fixing screw.
Steps for replacing bearings in the cutting mechanism.
How to adjust the cutter guard's mounting.
Procedure for setting the correct V-belt tension.
Torque specifications for various assembly components on BTS models.
To Next Page