7-10 BA D24 en/us* 1.0 * D24_1_0_700.fm
7 Maintenance
Important information regarding operation with biodegradable hydraulic oil
• Use only the biodegradable oils that have been tested and released by
Wacker Neuson.
• Add only biodegradable oil of the same type. In order to avoid misun-
derstandings, attach a label on the hydraulic oil filler inlet providing
clear information regarding the type of oil currently used.
The joint use of two different biodegradable oils can affect the quality of
one of the oil types. Therefore ensure that the remaining amount of
biodegradable oil complies with the national and regional regulations
as you replace it. Observe the manufacturer’s indications.
• Do not add mineral oil – the content of mineral oil should not exceed
2% of the system fill in order to avoid foaming problems and to ensure
biological degradability.
• When running the vehicle with biodegradable oil, the same oil and filter
replacement intervals are valid as for mineral oil.
• Always have the condensation water in the hydraulic oil reservoir
drained by a Wacker Neuson service center before the cold season.
The water content may not exceed 0.1% by weight.
• The instructions in this Operator’s Manual concerning environmental
protection are also valid for the use of biodegradable oil.
• Subsequent change from mineral oil to biodegradable oil may only be
performed by a Wacker Neuson service center.
To Next Page
Loading...
Need help?
General
