4-14 BA D24 en/us* 1.0 * D24_1_0_400.fm
4 Putting into operation
Protective structures
Protective structures are additional elements that protect the operator
against dangers. These elements can be installed later on or as standard
equipment.
Rollbar
• The rollbar has been specially designed for protection in case of an
accident.
• TOPS/ROPS tested rollbar.
Canopy/cab (option)
The cabin has been specially designed for protection in case of an
accident.
• ROPS/TOPS tested cabin.
The cabin complies with the FOPS level II requirements according to EN
ISO 3449:2008.
Accident hazard due to modified cabin or protective structures!
Modifications (for example drilling) weaken the structure and causes
serious injury or death.
► No drilling, cutting or grinding.
► Do not install any brackets.
► No welding, straightening or bending.
► Replace the complete protective structure if it is damaged, deformed or
cracked.
► Contact a Wacker Neuson service center in case of doubt.
► Retrofit, assembly and repair work may only be performed by a
Wacker Neuson service center.
► Replace self-locking fasteners.
► Screws to which an adhesive has been applied must be cleaned with a
suitable cleanser before they are re-used.
Machine operation is only allowed with a correctly installed and intact
rollbar or correctly installed and intact cabin.
For additional protection, only use correctly installed and intact Wacker
Neuson protective structures that have been released for the vehicle.
To Next Page
Loading...
Need help?
General
