Wacker Neuson SW10 User Manual

58
MAINTENANCE
CHECK AND TOP UP
CHECK, REPLACE OR TIGHTEN
REPLACE
CHECK, LOOK FOR THE CAUSES, FILL
UP
REPLACE, USE RECOMMENDED OIL
INSPECT AND IF NECESSARY, REPLACE
THE COMPONENT CONCERNED
ENGINE OIL LEVEL TOO LOW
THERMOSTAT FAULTY
RADIATOR BROKEN, FAULTY,
CLOGGED
AIR FILTER CLOGGED
COOLING FAN FAULTY,
BROKEN
MALFUNCTIONING OF WATER TEMPERA-
TURE INDICATOR ON DASHBOARD OR
BULB FAULTY
RADIATOR COOLANT
LEVEL LOW
BREAKAGE OF WATER / ALTERNATOR
PUMP
WATER PUMP BREAKAGE
BREAKAGE OF ENGINE COOLING FAN
CONTROL PUMP
BREAKAGE OF ENGINE COOLING FAN
TOP UP
INSPECT, CALL AN AUTHORISED
WORKSHOP
INSPECT, CLEAN OR REPLACE
CLEAN, REPLACE
INSPECT, REPLACE
INSPECT AND IF NECESSARY, REPLACE
THE COMPONENT CONCERNED
CHECK, TOP UP
INSPECT, REPLACE
INSPECT, REPLACE
INSPECT, REPLACE
INSPECT, REPLACE
ENGINE
OVERHEATING
STOP
IMMEDIATELY
CAUSE
REMEDY
FAULTY INJECTORS
ACCELERATOR BROKEN
POOR COMPRESSION
INSUFFICIENT POWER SUPPLY
(continues)
IRREGULAR
FUNCTIONING
FAULT
INSPECT, REPLACE
INSPECT, REPAIR
CALL AN AUTHORISED WORKSHOP
CHECK PLANT POWER SUPPLY,
REPLACE FUEL FILTER
PRESSURE LOW
ENGINE OIL
STOP
IMMEDIATELY
ENGINE OIL LEVEL
TOO LOW
PIPE AND CONNECTOR
OIL LEAKS
ENGINE OIL FILTER BLOCKED
OIL LEAK
INCORRECT ENGINE OIL
OIL PRESSURE WARNING LIGHT OR
BULB INEFFICIENT

Wacker Neuson SW10 Specifications

General

Brand	Wacker Neuson
Model	SW10
Category	Compact Loader
Language	English