Need help?Do you have a question about the Wadkin bursgreen and is the answer not in the manual?
Detailed technical specifications including dimensions, speeds, power, and weights for the planer.
Guidance on removing protective coatings and re-assembling exported parts like the fence and guard.
Instructions for connecting power supply, checking voltage, phase, frequency, and motor rotation.
Advice on keeping bright parts oiled and slideways clear, specifying types of oil and grease.
Instructions for machine installation, leveling tables, and foundation bolt considerations.
Steps to check and re-tension Vee belts, including cover removal and nut adjustments.
Detailed steps for removing, grinding, and re-setting knives using a setting gauge.
Procedure to verify knife setting parallelism to tables using a straight edge.
Advice on lubricating locking screws and checking for damage.
Details on cutter dimensions, balancing, and recommended angles for soft/hard woods.
Instructions to adjust fence angle and insert position for depth of cut.
How to adjust fence position across the table using rack and pinion.
Procedure to check and adjust 90° and 45° positive stops for the fence.
Tips on grain direction, table pressure, handling bad grain, and planing four sides.
List of spare parts for the 50-cycle machine, including motor, starter, and belts.
List of spare parts for the 60-cycle machine, including motor, starter, and belts.
List of spare parts for the single-phase machine, including motor, starter, and belts.
Specifies SKF and Fischer ball races for drive and rebate sides.
Details on H.S.S. planer knives, their size, and quantity per set.
Information about an optional rebate table for the front planing table.
Description of the power feed unit with sprung rollers, motor, and feed speeds.
To Next Page
General