Waeco CF40 - Setting the temperature

EN
CoolFreeze Operation
35
A
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
➤ Press the “ON/OFF” button (fig. 3 1, page 3) for between one
and two seconds.
✓ The “POWER” LED lights up.
✓ The display (fig. 3 5, page 3) switches on and shows the
current cooling temperature.
I
NOTE
The temperature displayed is that of the middle of the interior.
The temperatures elsewhere can deviate from this temperature.
✓ The cooler starts cooling the interior.
I
NOTE
When operating with the battery, the display switches off auto-
matically if the battery voltage is low. The LED “POWER” flashes
orange.
Locking the cooler
CF35, CF40
➤ Close the lid.
➤ Press the lock (fig. 2 1, page 3) down, until it latches in
place audibly.
6.6 Setting the temperature
➤ Press the “SET” button (fig. 3 4, page 3) once.
➤ Use the “UP +” (fig. 3 6, page 3) and “DOWN -” (fig. 3 7,
page 3) buttons to select the cooling temperature.
✓ The cooling temperature appears in the display for a few
seconds. The display flashes several times and then the current
temperature is displayed again.