EasyManua.ls Logo

WAGNER Evobell 3500 - User Manual

WAGNER Evobell 3500
88 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Evobell 3500
II 3G T6 X
"?
High rotation atomizer
Edition 05/2010
Translation of the original
Operating manual

Table of Contents

Questions and Answers

  • A
    Ana PachecoAug 9, 2025
    What to do if WAGNER Evobell 3500 have insufficient material discharge?
    • M
      Michael HarperAug 10, 2025
      If you're experiencing insufficient material discharge from your WAGNER Electronic Cigarettes, several factors could be the cause. The material tube diameter might be too small, in which case you should select a larger diameter tube. The material pressure could be too low, so try increasing it. If the material's viscosity is too high, thin it according to the manufacturer's instructions. Also, check if the filter in the material supply is clogged and clean or replace it if necessary. Finally, inspect the material tube for clogs and clean or replace it if needed.
  • C
    Chad EllisAug 14, 2025
    Why WAGNER Evobell 3500 have poor spray pattern?
    • M
      Michael ThompsonAug 14, 2025
      A poor spray pattern with your WAGNER Electronic Cigarettes can arise from several issues. First, readjust the material pressure or fan air if they are wrongly adjusted. Consider using a different material tube diameter if the current one is incorrect. If the material viscosity is too high, thin the material following the manufacturer's instructions. If the material pressure is too high, reduce it. Lastly, a damaged bell or distributor can also cause this issue, so replace them if necessary.
  • S
    Stacy ThorntonAug 19, 2025
    What to do if WAGNER Evobell 3500 Electronic Cigarettes are backspraying?
    • M
      Matthew KerrAug 19, 2025
      Backspraying with WAGNER Electronic Cigarettes can occur if the object isn't properly earthed, so check the earthing. It may also happen if the distance between the atomizer and the object is too large; try reducing this distance. Also, ensure that the fan air is working by checking it.
  • S
    Shelby PorterAug 25, 2025
    Why WAGNER Electronic Cigarettes material tube/distributor leaks?
    • R
      Richard PooleAug 25, 2025
      If the material tube or distributor of your WAGNER Electronic Cigarettes is leaking, it's likely due to damaged seals. You should exchange the seals to resolve this issue.
  • D
    David GalvanAug 29, 2025
    Why WAGNER Electronic Cigarettes have poor wrap-around?
    • D
      Dawn ThompsonAug 29, 2025
      Poor wrap-around with your WAGNER Electronic Cigarettes can be caused by poor earthing at the object. Check the earthing of the object or hanger with an ohmmeter to ensure it's properly grounded. Also, the paint resistance might be too high or too low, so check the resistance of the paint.
  • J
    Jennifer GutierrezSep 3, 2025
    Why WAGNER Evobell 3500 have unusual vibration (noise development)?
    • P
      parsonswalterSep 3, 2025
      Unusual vibration or noise development in your WAGNER Electronic Cigarettes can stem from a few causes. Damaged bell and distributor may be the reason, so replace them. Alternatively, receiver cone or drive turbine damage can also lead to this issue, in which case you should replace the drive turbine.

WAGNER Evobell 3500 Specifications

General IconGeneral
BrandWAGNER
ModelEvobell 3500
CategoryElectronic Cigarettes
LanguageEnglish