WAGNER FLEXiO 570 User Manual

TOLERANCES (except as noted)
MATERIAL:
Wagner Spray Tech Corporation
1770 Fernbrook Lane
Minneapolis, Minnesota 55447
DECIMAL
XX±
XXX±
FRACTIONAL
ANGULAR
TITLE: Quick-Start guide, FLEXiO Sprayers
THIS DRAWING & ANY ACCOMPANYING
SPECIFICATIONS ARE THE EXCLUSIVE
PROPERTY OF WAGNER SPRAY TECH.
MUST BE KEPT CONFIDENTIAL AND ARE
NOT TO BE USED OR REPRODUCED
WITHOUT THE WRITTEN PERMISSION
OF WAGNER SPRAY TECH CORP.
SCALE:
DWG. NO. 0529836
REV.
C
DR.
CH.
REF.
SHEET
SIZE
APP.
LET
REVISION
DATE
ECN
BY
CH
A
Release for print
12/04/12
27294
CL
CL
B
Multiple changes
05/02/13
27902
CL
CL
C
Nozzle changes
08/26/13
28228
CL
CL
Product Literature Specifications
1. 11” x 17” paper, printed both sides, folded through middle (Page labeled 1 or “Quick Start Guide” page should be shown
on top, page labeled 2 in the middle, page labeled 3 in the back).
2. 94 Brightness
3. 80 lb paper, white glossy
4. This page to be used for Quick-Start Guide material specifications only.
Delete this page before printing
Do not print this page
Uncontrolled Copy

WAGNER FLEXiO 570 Specifications

General

Power Source	Electric
Spray Patterns	Horizontal, Vertical, Round
Adjustable Settings	Material Flow
Nozzle	iSpray nozzle
Spray System	HVLP (High Volume Low Pressure)
Material Container Capacity	1.5 liters

Summary

Product Features Overview

Adjustment Ring

Component for adjusting spray pattern width or shape.

Spray Width Lever

Control for adjusting the spray pattern width.

X-Boost™ Power Dial

Adjusts the air power level produced by the turbine.

Filter Housing

Location of the air filter for the turbine.

2-Stage Trigger

Trigger mechanism allowing separate turbine and material flow control.

Material Flow Control

Adjusts the amount of spray material dispensed.

1.5 qt Cup

Container for holding the spray material.

Detail Finish Nozzle™™

Specific nozzle type for fine detail spraying.

Cleaning and Maintenance

Safety Warnings

Setup and Preparation

Material Selection and Control Settings

Spraying Techniques and Controls

Material Flow Control

Controls the amount of spray material dispensed by the gun.

Spray Width Lever

Adjusts the width of the spray pattern for iSpray nozzles.

Adjustment Ring

Modifies the spray pattern shape (vertical, horizontal, diagonal).

X-Boost™ Power Dial

Regulates the air power level produced by the turbine.