WAGNER Power Roller User Manual

6
English
Title
1
. Remove suction tube from paint can and place in bucket
of appropriate cleaning solution (warm, soapy water for
latex paints, mineral spirits for oil-based paints).
2. Remove spatter shield. Press locking tab
(a) and drop
roller cover assembly into a bucket of the appropriate
cleaning solution.
3. Insert thumb to first knuckle, PRY and PULL the cap from
the roller cover. Once the cap is removed,
PUSH the
core out the other end.
4. Remove lid and hold roller arm over paint can. Make sure
switch is turned to PAINT. Press and hold handle button to
pump paint through hose and into paint can. Release
handle button when cleaning solution reaches the paint can.
(a)
When you are finished with your project, follow these steps to return any remaining material left in the hose back into its
container. These steps should be followed no matter what type of material you used.
Make sure your floors and furnishings are protected from
dripping paint when removing or disassembling the roller
assembly
. Drop the parts into a bucket of the appropriate
cleaning solution while you clean the unit.
Cleanup - Purging the paint hose

WAGNER Power Roller Specifications

General

Brand	WAGNER
Model	Power Roller
Category	Power Roller
Language	English