GB
SIDNEY
4
Operating Instructions
Congratulations on the purchase of your WAGNER suspended lamp SIDNEY.
Read the operating instructions carefully before putting the device into operation and
observe the safety instructions. Keep the operating instructions in a safe place.
Note! Your SIDNEY is weather-resisting and should be operated with direct
exposure to solar radiation. Erect your SIDNEY so that it receives
maximum exposure to the solar radiation to increase its capacity.
SIDNEY is equipped with a NiCd-rechargeable battery. This rechargeable
battery is not loaded upon delivery. After the device has been put into
operation, the rechargeable battery requires ca. 3 days of sun to attain its
full capacity. For this first charging, the main switch must be set to „OFF“.
ASSEMBLY (1 - 3)
Carefully remove your SIDNEY and the fittings out of the box.
CAUTION! Do not exert pressure on the solar panel, as this may cause damage
to the solar module!
When digging and drilling holes, make sure that you do not come
into contact with hidden cables. Contact with hidden cables can re-
sult in serious injury or even death!
● Put the pole into the ground spike.
● Drive the ground spike into the ground.
Technical data
Solar field Mono-crystal
Size ca. 3250 mm²
Capacity at full exposure to solar radiation ca. 0,30 W
Rechargeable battery NiCd
Voltage 2 x 1,2 V
Loading capacity 600 mAh
Luminous element white LED
Duration of emission of light max. 10 h
To Next Page
Loading...
Need help?
General
