WAGNER SteamForce Pro - Correction of Malfunctions; Technical Data; Accessories

EN
12
SteamForce Pro
16. Correction of Malfunctions
Malfunction Cause Remedy
Unit fails to boil
•
The thermal cut-out has operated
•
Usage of an extension lead
Switch o, allow to
cool, rell with water
then switch on again
Check that the thermal
reset button has not
tripped out.
Check that the
extension lead is rated
at minimum of 15
Amps (EU)/ 13 Amps
(UK) - 230V unit only
and fully unwound.
Unit keeps cutting
out
•
Water is below MIN level
•
Usage of an extension lead
•
Additives have been used
Rell water
See above
Refresh water
Steam escaping
from pressure cap
•
Blockage in hose or steamplate
•
Build up around cap area
Remove blockage
Clean seating around
cap area
i
If the unit still will not operate return the unit to the dealer or authorised agent
for investigation.
17. Technical Data
Power source: 220-240 V ~ 50Hz Power consumption: 2750W
Steaming time:
80-100 Minutes Hose length: 5 m
Boiler capacity:
7.5L Unit weight: 9.4kg
Max persons: 1 Max standing weight: 127kg
18. Accessories
Further information about the WAGNER range of products for decorative preparation is
available on www.wagner-group.com.