WAGNER W100 - Page 11

20
W 100
EN
4. Description/ Scope of delivery
Description/ Scope of delivery (Fig. 1)
1) Air Cap 2) Nozzle
3) Union nut 4) Spray gun front part
5) Trigger 6) Spray gun rear part
7) Material volume adjustment 8) Air lter cover
9) Mains lead 10) Container
11) Ventilating hose 12) Valve
13) Stir stick 14) Operating instructions
15) Replacement nozzle seal* 16) Lubricating grease*
* This is inside the container: remove it before starting operations!
5. Coating Materials Suitable for Use
Water- and solvent-based paints, nishes, primers, impregnations, staining sealers, wood
sealer-preservatives and oils.
6. Coating Materials Not Suitable for Use
Wall paints, alkali and acidic paints. Flammable materials.
7. Preparation of the Coating Material
The enclosed spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted. Detailed information is available in the technical data sheet
of the manufacturer ( Internet download).
1. Stir the material up and put the required amount into the paint container.
Thinning recommendation
Sprayed material
Glazes, wood preservatives, mordants, oils,
impregnations
undiluted
Paints containing solvents and water-soluble paints,
primers dilute by 5 - 10%
2. If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulls your requirements.