Blade Cleaning and Assembly
9649 Cordless Colour Pro Clipper Kit
1 Press your thumbs against the teeth of the blade and push away from the clipper (Fig B)
2 The blade assembly will come away from the clipper as a complete unit (Fig C)
WARNING - the blade screws (Fig A4) should NEVER be removed
Cleaning and Oiling the Blade Assembly
1 Once the blade has been removed use a soft brush to clean away and hair or dirt.
2 Oil the blade with a drop of oil in the 5 positions shown in Fig D
3 Wipe away any excess oil
4
Fig D Fig E
1
2 Oiling should be carried out at first use and after every cut - ensure excess oil is wiped away.
3
Top Blade and Black Blade Cam Follower
Fig A - Blade Assembly Parts List
Replace the blade, the clip on the bottom of the blade assembly should be located in the bottom of
the clipper housing, then push the top of the blade back towards the clipper. Fig E
If your clipper is no longer cutting correctly, snagging the hair or has become load / noisy please follow
the steps above to clean and oil the blade.
Clipper not holding charge - a dry, dirty and stiff blade will drastically reduce the run time of the
clipper - clean and oil regularly.
U:\Departments\Service\Returns Analysis\Products\9649-017 Colour Pro Cordless\Pictures-9469\9649 Blade
Assembly Data Sheet
To Next Page
Need help?
General
