How to Pair your TICKR to the Wahoo Fitness app (iOS)
Download the Wahoo Fitness app from the App Store.
Open the Wahoo Fitness app. Make sure you have Bluetooth turned on.
Wake up your TICKR by wearing it on your chest. The TICKR wakes up when a heartbeat is
present.
Select "Sensors” in the bottom left corner.
Select "Add New Sensor”.
Choose your TICKR from the list of available sensors.
Once certain you are connected to the correct sensor, select "Save Sensor”.
Choose the workout profiles you would like your TICKR to be active for (ex. Running & Cycling).
Select "Done” to complete the pairing & workout selection process.
Select "Done” in the top left corner to exit the Sensors menu.
How to Pair your TICKR to the Wahoo Fitness app (Android)
Download the Wahoo Fitness app from the Google Play Store.
Open the Wahoo Fitness app. Make sure you have Bluetooth turned on.
Wake up your TICKR by wearing it on your chest. The TICKR wakes up when a heartbeat is
present.
Select "Saved Devices” in the top right corner.
Select the plus "+” icon to add a new sensor.
Choose your TICKR from the list of available sensors.
Once certain you are connected to the correct sensor, select "Save Device”.
Choose the workout profiles you would like your TICKR to be active for (ex. Running & Cycling).
Select "Ok” to complete the pairing & workout selection process.
Use the Back button to exit the menus and return to the Home Screen.
Your TICKR is now set up and ready for action. To use your TICKR, start a workout with one of
the profiles you paired it with. The Wahoo Fitness app will remember this pairing in the future.
You simply need to wake up your sensor and start a new workout to begin recording data!
NOTE: The TICKR Heart Rate Monitor uses a Blue and Red LED to give instant feedback to the
user during the pairing process. These LEDs operate for about 30 seconds to conserve battery.
The Red LED flashes each time a heartbeat is detected. The Blue LED represents your
connection state and has three modes:
Slow Blink (about once every second): TICKR is awake and not paired
3x Flash: Occurs the instant a connection is made.
Quick Blink (about twice every second): TICKR is paired to a device.
If a firmware update is available for your sensor, the Wahoo Fitness app will now prompt you to
proceed with performing an update. If you do not, the update may be performed later. Sensors
with updates available will appear in the menu of Saved Sensors marked with a badge to indicate
the update is available but not installed.
To Next Page
Loading...
Need help?
General