WALDOOR AUTOMATIC DOORS
Accustraat 21, P.O. Box 94, 3900 AB, Veenendaal (NL), Tel.: +31 (0)318-532333, Fax: +31 (0)318-532339
Traderegister 30080679, E-mail: waldoor@waldoor.nl, Internet: www.waldoor.nl
User Instruction Waldoor
®
Sliding Door Operator UWS and WM1-A
1. Line cable (230V AC with earth)
2. Motion detector
3. Cover
4. Fixed side panel
5. Door leaf
6. Photocells (1 or 2 sets)
7. Programme switch (PGS)
8. 3-Position programme selector switch
9. Night switch (key or pushbutton)
10. Handle (optional) for hermetical doors
11. Manual unlocking (optional)
Display:
-8-
General fault. See the display in the PCB
-A
- Battery fault. (Press 1 x on “reset”. The battery
test is repeated after 1 hour, etc.).
-0-
Same as -A- on older versions type 2. (Visible
on the PGS after switching on the line power).
-E-
Pull open cord defect.
By pushing shortly the
RESET
button on the PGS,
the com
uter tries to re
air a
ossible fault
Programming
Wo = winter open width
So = open speed
Sc = close speed
To = open time
·
Push RESET ± 5 sec. until all led’s
are flashing.
·
Press repeatable on the desired
button (So, Sc of To) and select the
right value 0 (min.) until 9 (max.)
·
Close by pressing RESET.
WINTERSTAND
IN /UIT
Learning cycle:
During a delay time of 5 sec. the
PGS
shows a “
3
” (or a “
2
” on older versions) and
all led’s are on.
fter these 5 seconds all led’s are off except
UTOMATIC.
The door will close now maximum on the
lowest speed the computer has found.
fter that the door will fully open on the
lowest speed. During this opening cycle a
brake test is carried out.
fter the door has fully opened against the
end stop the door will close on normal speed
and is ready to use.
Use of the programme switch (PGS)
Automatic
Exit
Closed
open
Winter position
Sequence function
Display
Reset button
Hard Reset:
1- Switch off and on again the 230V or
2- (
³
1.90) Press reset 5 sec. until all led’s
are flashing and then 5 sec. on the
sequence button until all led’s are off.
To Next Page
Need help?
General