Page 9
13. DO disconnect the mains plug or isolate the supply before:
a. Emptying fluid from the tank
b. Filling the tank with fluid
c. Moving the unit
d.
Removing the base screws
(NO USER SERVICEABLE PARTS ARE
CONTAINED IN THE UNIT.)
14. DO keep the front panel dry. NEVER allow fluid to run down the unit
case or around the IEC socket area.
15. DO NOT operate any switches when your hands are wet.
16. DO use the correct accessories with the unit. DO NOT use any glass or
other containers in place of the recognised beaker.
17. The unit should be operated in an environment as follows:
Temperature: 5°C to 40°C. Humidity: 10% to 80%
(non-condensing)
18. After periods of operation the top of the tank and fluid may get warm.
This is quite normal.
19. To clean the case and tank wipe with a lightly oiled cloth.
20. DO NOT move the unit whilst in use or connected to the mains supply
in order to avoid spillage and/or a possible shock hazard.
21. In the event of failure/emergency, disconnect the mains supply by
removing the plug from the mains socket.
22. It is advised that during operation the minimum distance between any
person and the equipment is not less than 1 metre.
23. DO NOT Flash test this equipment.
24. When the unit is used in Dentistry, refer to HTM0105 for instructions
on daily, weekly, quarterly and yearly test or visit
www.walkerelectronics.co.uk for more information
IF THE EQUIPMENT IS NOT USED AS SPECIFIED IN THIS
HANDBOOK THE PROTECTION PROVIDED BY THE
EQUIPMENT MAY BE IMPAIRED.
THE ABOVE LIST IS NOT EXHAUSTIVE.
To Next Page
Loading...
Need help?
General