Page 7
alternative cleaning methods…
Fig. 1 shows cleaning in a 600ml beaker.
The tank should be half filled with fluid. It is most important that the fluid is
NOT water alone, but water and detergent or another cleaning fluid. The
stand should be placed on top of the unit with the locating lugs pointing
down. Beaker stands are available in single and double beaker formats. The
rubber ring should be slid up or down the beaker so that when put into the
beaker stand the base of the beaker is between 21/2cm (1") and 5cm (2")
below the surface of the fluid but not touching the base of the tank. CARE
SHOULD BE TAKEN not to lower the beaker too far as the fluid may flow over
the top of the tank. The ultrasonic cleaner may then be operated (Refer to
pages 4 & 5).
This method is particularly useful for cleaning small components.
Fig.2 shows the cleaning method using the basket
*
The fluid level should always at the level of the filling ridge in the tank. The
item/s to be cleaned should be placed in the basket, which should be then
gently lowered into the tank.
CARE SHOULD BE TAKEN when lowering the basket as the fluid could flow
over the top of the tank. The ultrasonic cleaner may then be operated (Refer
to pages 4 & 5).
The single beaker stand and the basket can be used simultaneously,
however the double beaker stand must be used without the basket.
*
The basket supplied may vary from the one pictured
To Next Page
Loading...
Need help?
General