6
The winch is designed for 3 point hitch mounting, and is powered by the
tractors Power Take Off.
NOTE: If the PTO shaft is too long, the winch bearings or the tractor’s
transmission may be damaged if winch is lifted and the shaft is under
pressure from being too long. However, shaft must have adequate over-
lap on telescoping tube. (see instructions below)
Mount the winch to the tractor’s three point hitch.
The PTO shaft may be too long and may need to be cut to length
during initial installation. When shortening shaft: (a) cut the same
amount off of each end of PTO shaft (b) there should be approxi-
mately 1/2” of clearance in PTO shaft when winch and tractor are a
nearest point. (c) remove burrs from shaft before assembling PTO
shaft.
1.
2.
To Next Page
Loading...
