Need help?Do you have a question about the Walrus Audio MAKOSERIES R1 and is the answer not in the manual?
General| Analog/Digital | Digital |
|---|---|
| Type | Reverb |
| Footswitches | 2 |
| MIDI | In/Out |
| Power Supply | 9V DC power supply |
| Power Requirements | 300mA |
| Input Impedance | 1MΩ |
| Output Impedance | 100Ω |
| Bypass | True Bypass |
| Controls | Decay, Swell, Mix, Tweak, Program |
Details the Spring program, emulating spring reverb with bouncy drip and tube amp characteristics.
Describes the Hall program, simulating acoustics of large live sound spaces like concert halls to arenas.
Explains the Plate program, emulating smooth analog plate reverb inspired by famous plates.
Details the BFR program, offering a massive, hall-esque reverb with rich and lush decay.
Describes the RFRCT program, providing lovely, charming, and glitch-like textures.
Explains the Air program, offering a larger diffused reverb with a subtle shimmer and crisp clarity.
Descriptions of the Decay, Swell, and Mix knobs for controlling reverb length, envelope, and wet/dry mix.
Details the Tweak knob and selectable parameters: Rate, Depth, and Pre-Delay for shaping reverb.
Information on the Prog knob for program selection and Tune knob with Lo, High, X parameters.
Control for stereo width, plus descriptions of Bank and Bypass switches.
Explanation of Bypass LED, Sus/Latch Switch/LED, and Audio I/O configurations.
Procedures for recalling and saving presets using the pedal's switches.
Instructions on how to change the pedal's bypass mode (True, DSP+True, DSP).
Method for resetting the pedal to its original factory default settings.
Details on connecting MIDI devices and assigning the pedal's MIDI channel.
Mapping presets to MIDI Program Change and controlling parameters via MIDI CC messages.
Information on where to find new features and firmware updates for the R1 pedal.
To Next Page
