9
2. Position 3-way Control Valve (B) toward desired direction of solution ow.
Solution can ow through both the exible faucet (A) and the ow-through brush
(C) simultaneously when the handle is positioned mid-way between the two.
3. Turn the cleaning pump ON & OFF by pressing ON/OFF switch (E).
To minimize uid consumption, always turn the cleaning pump OFF after use
by pressing the pump switch (E) again.
Wet the sink, parts to be cleaned and any brushes prior to cleaning; this will
prevent grease and dirt from sticking to the surfaces.
The BIO-CIRCLE™ unit is supplied with an efcient multi-jet ow-through
brush, which is well suited for most cleaning applications. However, for best
results, when cleaning smaller or intricate parts, it is recommended to run
the cleaning solution through the exible faucet (A) and use brushes that are
well adapted to the shape of the part being cleaned. Always clean parts while
holding them under the ow of liquid.
4. For optimum performance, always keep unit topped-up to the proper
working level of at least 80 L/21 gal., do not ll above the MAX level. Do not
allow solution level to fall below 55 L/15 gal. Observe uid level lines molded
into the tank wall.
When the solution level falls below minimum, the oat switch will cut power to
the cleaning pump and the heater coil. The air pump, however, will continue
running. Check the uid level every other week and top-up to operating
level.
Note: The cleaning pump will start automatically after the uid level has been
topped up if the cleaning pump switch (E) is in the ON position. To prevent spills,
always put switch (E) in the OFF position when the oat switch has cut power to
the cleaning pump.
90 L
75 L
60 L
To Next Page
Loading...