Storage
77
Decommissioning
NOTE!
Contact a specialist workshop if you do not have experience with
the decommissioning of power generators.
If you do not want to use the power generator for a long period of time,
then decommission it. To do this, drain the engine oil and petrol tanks
and conserve the engine.
• Clean the power generator (see chapter "Cleaning").
• Drain the engine oil (see chapter "Draining the engine oil").
• Drain the petrol tank, e. g. using a suitable suction pump.
• Remove the spark plug connector
19
with a slight upward turning motion.
• Turn the spark plug counter-clockwise using the spark plug spanner
6
.
• Apply about 1 ml of engine oil to the spark plug opening, e. g. using a suitable
syringe.
• Tighten the spark plug in clockwise direction by hand as far as it goes.
• Carefully tighten the spark plug using the spark plug spanner. Do not apply a
lot of force.
• Pull the handle
17
two to three times slowly.
• Replace the spark plug connector.
The engine is conserved and the power generator can be stored (see chapter
"Storage").
K640061_Anleitung_DE_EN_FR_CZ_SI.indb 77K640061_Anleitung_DE_EN_FR_CZ_SI.indb 77 08.02.2021 14:53:3108.02.2021 14:53:31
To Next Page
Loading...
Need help?
General