WAMETA MULTIMIG PRO 180 SYN - Technical Information; Description of the Device; Introduction

38
Description of the device
Wameta MULTIMIG PRO 180 SYN is an inverter rectifier. The device is
connected to a 1-phase 220-240V 50 / 60Hz power supply. Fuse size 16A slow
blow. The device is designed for MIG/MAG, MMA, and DC TIG welding with lift
ignition. (TIG torch sold separately). Use for any other purpose is prohibited.
Introduction
Remove the device and accessories from its packaging. If you no longer want to
use the packaging for transporting or storing the machine, Take care of recycling
the packaging materials.
Check that the following products are
available on the packaging.
Check that the machine or equipment
does not show any transport damage
and that no part of the machine or
equipment has come off. Transport
damage must be reported to the
carrier.
Technical information
M
odel
Wameta MULTIMIG PRO 180 SYN
Mains voltage
U
1
V
230
Mains
frequency
Hz
50/60
Ma
ximum input
current
I1
max
A
32
Rated input
current
I1
eff
A
16
Maximum input power kVA
7.4
Open circuit voltage
MMA
V
69
MMA
MIG/MAG
TIG
Arc voltage
V
20.8
-
26.4
15.5
-
23.0
10.6
-
17.2
Welding current A
20～160
30-180 15-180
ED A @ 40°C 25%
160
180
180
ED A @ 40°C 60 %
98
116
116
ED A @ 40°C 100 %
76
90
90
Efficiency
η
85%
Power factor
Cosφ
0.75
Insulation class
H
Protection class
IP
21S
Cooling type
Fan
Measurements cm
L
×
W
×
H
55×22×38
Weight
kg
14 kg
Product Amount
Welding machine
1 pc
MIG/MAG welding
torch
1 pc
Earth cable
1 pc
Gas hose
1 pc
User manual
1 pc