Need help?Do you have a question about the W&H Assistina MB-302 and is the answer not in the manual?
General| Application | Cleaning and lubrication of dental handpieces |
|---|---|
| Function | Automated cleaning and lubrication |
| Power supply | Pneumatic (compressed air) |
| Weight | 3.5 kg |
| Type | Maintenance device |
| Cleaning process | Automatic |
| Lubrication | Automatic |
| Cleaning System | Integrated |
| Sterilization | Not applicable |
Unit for cleaning spray channels and lubricating moving parts of dental handpieces, turbines, air motors, and scalers.
The device is designed for dentists, dental hygienists, and dental assistants.
Describes the operating controls, cartridge compartments, and chambers of the front panel.
Details the various LEDs and their functions on the device's front panel.
Explains the components of the HPI adaptor, including O-rings, release button, and seal.
Identifies the USB port and connection sockets on the rear of the device.
Instructions for removing and inserting cartridges into the device.
Steps for inserting and removing the air filter from the device.
General information related to starting up the device, including air supply.
Procedures for connecting and disconnecting the air hose.
Steps for connecting the power supply unit to the device.
Instructions on how to power the device on and off.
Guides the user through the initial filling process for the device chambers.
Explains how the device enters standby mode and how to activate it.
Instructions for performing a test run after setup and initial filling.
General precautions and recommendations for operating the device.
Step-by-step guide for connecting and disconnecting the HPI adaptor.
Procedures for loading and removing transmission instruments with ISO or Roto Quick connection.
Procedures for loading and removing transmission instruments with a fixed RM connection.
Details the automatic maintenance process for the device.
Instructions for performing oil service on the chucking system.
Manual cleaning instructions for the interior and exterior of the device.
Manual cleaning instructions for the sliding window.
Steps to follow to start up the device after cleaning.
Step-by-step guide for replacing the O-rings on the adaptor.
Instructions for replacing the air filter in the device.
Describes the error state where the device is in standby mode and no LED is lit.
Error state indicating the device is not connected to power.
Error state indicating an electronics malfunction, LEDs are red.
Error state when the sliding window is open.
Error state indicating an issue with the air supply.
Error state when the maintenance process fails.
Error state when maintenance fails due to air supply issues.
Error state where initial filling fails.
Error state where initial filling fails due to air supply issues.
Indicates that the device cartridges are running low.
Indicates that the device cartridges are empty.
Error state when the oil service for the chucking system fails.
Error state when oil service fails due to air supply issues.
Instructions for sending the complete device for repairs if defects occur.
Guidance on returning devices, including contacting service partners and packaging.
To Next Page
