Need help?Do you have a question about the wanscam HW0036 and is the answer not in the manual?
Connect the camera with an internet cable and power it on.
Open the CD, install the software by following the on-screen prompts.
Get the E-view7 app from Google Play or App Store for your IP Camera.
Steps for using the 'One Key Setting' function in the app for initial setup.
Input P2P ID, username, and password manually, then click 'Save'.
Scan the camera's QR code with your phone to get ID, then input credentials and save.
Search for cameras on the LAN, select one, input credentials, and save.
Select the correct SSID and enter the WiFi password to connect the camera.
After WiFi connection, the camera reboots; it will appear online in 3-5 minutes.
Run the search tool to find the camera's IP address automatically.
Double-click the IP address to open the login interface in a browser and enter credentials.
Options for livestream (IE), videostream (Firefox), snapshot (smartphone), and SD card playback.
Refresh the webpage after OCX installation to display the live camera video feed.
Access 'Device Information' settings to view firmware, device ID, MAC, and status.
Navigate to 'Alias Settings' to set or change the display name of the camera.
Configure the device clock, timezone, and NTP server synchronization.
Set parameters for local recording, including file length, time, and disk space.
Specify where to store video files and set the maximum length for each file.
Set record time length, reserved disk space, and record cover options.
Paste the camera's IP address into an IE browser to access its settings page.
Specify the directory on your computer to store local video recordings.
Set up record coverage, audio, and timer recording for the SD card.
Access and playback recorded video from the SD card using the IE browser.
Set up mail service (e.g., Gmail) to receive photos via email upon camera activation.
Set motion detection, audio sensitivity, and other alarm triggers for notifications.
Set up FTP server, port, user, and password for file uploads.
View the system log for administrators to monitor alarm events and system status.
Configure network settings like IP address, subnet mask, gateway, and DNS servers.
Search for WiFi signals, select SSID, enter key, and check connection status.
Support ONVIF function and RTSP stream function by enabling them.
Set PTZ functions like signal lamp, preset on boot, speed, and cruise views.
Change the password for user accounts like Visitor, Operator, and Administrator.
Refresh the LAN search to find and add other cameras to the system.
Options to reboot the camera, restore factory settings, or upgrade the system firmware.
Download and install the E-View7 app on iOS or Android devices.
Methods to add the IP camera to the app: P2P ID, QR Code, LAN search, or One Key Setting.
Familiarize with the app's interface, including Device List and Live Video controls.
Controls for live video: Mirror, Brightness, Contrast, Listen/speak, Snapshot, Video, Pattern, IR Switch.
Reset the camera to factory settings by pressing the RESET button for 10 seconds.
Resolve black screen issues by enabling ActiveX controls in IE security settings.
Ensure ActiveX settings like 'Download unsigned ActiveX controls' are set to 'Enable'.
Information regarding FCC rules, limits for Class B digital devices, and interference.
Requirements for RF exposure compliance, including antenna separation distance.
To Next Page
General
